Nowadays, when decorating houses, many people would like to design the house decoration more and more. Therefore, when choosing lighting fixtures, they will choose crystal lamps, crystal clear light bulbs, and the actual effect of varnish is better. , But after installing the crystal lamp, it looks beautiful, cleaning and maintenance become a problem. The crystal lamp needs to be cleaned and maintained 1 to 2 times a year to remove the adhering dust and dirt to ensure the crystal lamp is colorful and elegant. In addition, the maintenance of the crystal lamp of the crystal lamp manufacturer must also be carried out in the following many aspects.
1. When installing or disassembling the crystal lamp, be sure to wear milky white, neat cloth gloves, except for part of the hardware configuration of the lamp. If there are floor tiles under the light bulb, you must remember to lay the carpet to prevent the crystal from crushing and ensure safety.
2. When installing or disassembling the crystal lamp body, be sure to maintain the balance of the crystal lamp body, especially for large and medium-sized crystal ceiling lamps, which should be installed or disassembled front and rear, left and right, otherwise it will cause the crystal lamp body to deform or break, and the lamp cannot be rotated. Arm, to prevent the screw teeth from loosening and causing unsafe production accidents.
3. When cleaning the hardware lamp holder, it must be scrubbed with a dry cotton cloth, not a pure cotton cloth moistened with cold water or ethanol, to prevent scratches on the protective film outside the electroplating process layer and harm the gloss of the surface layer of the hardware lamp holder (true Electroplating gold can generally last three to five years or longer without fading).
4. When cleaning the crystal lamp, the removed crystals must be separated by newspapers and periodicals to prevent the crystals from being scratched by hitting each other. In addition, the crystal lamp discs cannot be placed together. Please use a damp cotton cloth to dry and wipe gently, and then use a dry cotton cloth to wipe off the remaining water marks. Be careful, you don't have to pull down when scrubbing the crystal to prevent the beads from cracking.
5. When cleaning and maintaining the crystal lamp, check the embedded parts, lifting hooks and chains in the decoration ceiling to ensure the load; check whether the lamp arm connection is strong, if you find it loose, you should tighten the screw If there is a slippery tooth, it should be removed and replaced immediately to ensure safety; check whether the internal wiring is intact and whether the hardware connection between the crystal is air oxidized, and it should be removed and replaced according to the condition.
6. Beautiful and generous adjustment: the arm spacing should be well-proportioned and the height should be the same; the lamp cover should not be placed slantingly, and the seams should be flushed inward.
In addition to cleaning and maintaining the crystals, the embedded parts and load lifting hooks and chains inside the ceiling should also be inspected to avoid embrittlement and undetected; in addition, check whether the characteristics of the internal wiring are intact, if there is dirt, Embrittlement, it should be replaced immediately. The above is a brief introduction to the maintenance of crystal lamp by the crystal lamp manufacturer Longwest, I hope it will be helpful to you.
